If the service light is on press the * key followed by the 2 key to determine the service condition. The service light will be on if the security system requires service. Identifying Service or Trouble Conditions

The zone # that is lit indicates the digit of the code (for 9 zones 1 & 8 will be lit).įlashing power light means low battery. Press Enter user # (3 digit # for NX-8E) Press the down arrow (press the arrow 4 times to see all 4 digits of the user code) and the zone LED’s will light up. To bypass a zone press the Bypass key then the zone number then the Bypass key twice If the chime is off the CHIME light will be off. If the chime is on the CHIME light will be on. The door chime is turned on or off by pressing the CHIME key while the system is in the disarmed state. ** Do NOT delete user 1 Activating the Chime Mode: To Delete a user code enter **** for a 4 digit code after step 3. To delete a user code enter **** for a 4 digit code after step 3.

Step 5 – Press the # key while the ready light is flashing to exit the User Code Programming Mode. Step 4 – Enter the new 4 digit user code. Step 3 – Enter the 2 digit “user number” (example: 01 for user #1 if changing Master Code.)

Step 1 – Press *5 and the Master Code (main user code). System must be disarmed to change user codes Interlogix NX-4 NetworX 4 Zone Control Panel Changing and Adding User Codes NX-4, NX-6, or NX-8 interlogix NX-4 NetworX 4 Zone Control Panel User Guide.

Networx nx6